Page 10 of 10
Posted: Mon Feb 27, 12 3:10 pm
by autofetish
Great work John was not long ago i was wheel spinning up that grass
Keep the info coming scaffold ramp great
Posted: Mon Feb 27, 12 7:41 pm
by JohnR
Thanks guys the frame was Kevs idea just rolled it off the lorry onto the frame
Dunc. it will have a support under the box , I am cutting down the stock X member as I only have one bolt hole on each side left , I had to remove the upper frame from the tunnel on the inside to make room for the box , only had to cut a small hole so far in the side of the tunnel to get gearbox in will post some more pics later
Posted: Mon Feb 27, 12 9:01 pm
by Cannonball
JohnR wrote:Thanks guys the frame was Kevs idea just rolled it off the lorry onto the frame
Dunc. it will have a support under the box , I am cutting down the stock X member as I only have one bolt hole on each side left , I had to remove the upper frame from the tunnel on the inside to make room for the box , only had to cut a small hole so far in the side of the tunnel to get gearbox in will post some more pics later
yes john i can see that. what i meant was i would have kept all the bracing that follows the tunnel just pushed it higher up if you can under stand me i dont think that would interfere with anything inside the car...
yes i have fitted a few of them 4 speeds and its tight,
Posted: Mon Feb 27, 12 9:44 pm
by mopar_mark
Is that a
Spaghetti Menders Wiring kit ? !
Good to see your still hard at it, ramp was a good bit of ingenuity & must make life a bit easier
Posted: Tue Feb 28, 12 5:34 pm
by JohnR
Looks like it Mark, that,s some of the wires for the fuel injection ,I have to extend them so I can put the ECU on the bulkhead . but it all works !!!!!!
Dunc I get what you are on about , but I thought I would do it this way have to see how it works out !! have to go back to Pets at Home to get a new cat toy as I broke mine getting the engine out
Posted: Sat Mar 03, 12 7:44 pm
by Anonymous
Flipping hell John, it only went in for a bit of bodywork.
Really would like to go down this road, with a late V8 lump.
Good work lads, cant believe you got Dell doing a bit
N/A
Posted: Wed Jun 06, 12 7:59 pm
by autofetish
Posted: Fri Jun 15, 12 12:48 pm
by Stu
Wow, John! That looks a bit different to last I saw it! Haven't been on for ages, so missed a lot of this work, but it looks like you guys will be proud wit the results.
You are motivating me to get my arse in gear.
