Posted: Thu Mar 08, 07 11:33 pm
Blimey! Thanks In Advance! 
Mopar Muscle Association UK
The premier Mopar club in Europe!
https://moparuk.com/forums/
Mopar build quality.
Page 2 of 2
Posted: Thu Mar 08, 07 11:38 pm
yep poor build quality , i would be surprised if two cars had the same measurements in that area
Posted: Thu Mar 08, 07 11:39 pm
Lookin back @ yer posts, never realised you were so polite. 
Posted: Thu Mar 08, 07 11:41 pm
................... 
Posted: Thu Mar 08, 07 11:45 pm
steveo wrote:
Refering to Kevs "tia" post, which means "thanks in advance"........
Posted: Thu Mar 08, 07 11:53 pm
just read all the posts 
Adam i sent you a PM last night
Posted: Fri Mar 09, 07 10:59 am
When I moved my springs in a bit I had to move the spring perches on the axle anyway so I centered the axle under the body then.
It is more critical that you have exacly the same length from the front wheel center to the rear axle center. This can be out too. The fix is shims behind the front leaf spring hanger.
It is more critical that you have exacly the same length from the front wheel center to the rear axle center. This can be out too. The fix is shims behind the front leaf spring hanger.
Posted: Fri Mar 09, 07 3:42 pm
I was quite suprised at the way the panels were joined on my Charger, its like they put the floor pan near the sill, and thought.. that'll do, and just started spotwelding it on, one end was 1/4 inch above the bottom of the sill, and the other end was 1/4 inch below ! Front of car wasn't much better, which becomes apparent when welding in replacement panels. I guess thats why all the bolt holes are slotted !
Fury seems better.
Fury seems better.