Shipping used Nitrous bottles

Pete · Post by **Pete** » Sun Jun 08, 08 9:55 pm

Bum. Useful information thanks - that may have saved me a costly mistake

Anonymous · Post by **Anonymous** » Sun Jun 08, 08 9:57 pm

pete walton wrote:Adam what do you know about drilling a tunnel ram to take nitrous?????

You could have a look @ duncs tunnel ram , was for sale.

Anonymous · Post by **Anonymous** » Sun Jun 08, 08 9:59 pm

Pete , take a look how many have looked @ this thread.

I did'nt get that many after a couple of days.

Pete · Post by **Pete** » Sun Jun 08, 08 10:00 pm

That was a 6 pack one with spray, neat job.

Pete · Post by **Pete** » Sun Jun 08, 08 10:01 pm

Brutus wrote:Pete , take a look how many have looked @ this thread.

I did'nt get that many after a couple of days.

Blimey! Explain that???

Pete · Post by **Pete** » Sun Jun 08, 08 10:03 pm

I have already ordered a Dominator spray plate, just need the other bits and pieces.

I think the Sox will need nitrous to run the numbers; I was just toying with fitting a basic system on Julie's car for the Nats.....

Anonymous · Post by **Anonymous** » Sun Jun 08, 08 10:06 pm

What kit have you gone gone for Pete?

Jeff · Post by **Jeff** » Sun Jun 08, 08 10:07 pm

Go for the burst plates Pete.... Have a word with me mate Frank in Florida... Been running 9's in a street legal car for about 7 years now.... Still on the same motor.

Anonymous · Post by **Anonymous** » Sun Jun 08, 08 10:10 pm

Jeff wrote:Go for the burst plates Pete.... Have a word with me mate Frank in Florida... Been running 9's in a street legal car for about 7 years now.... Still on the same motor.

No need for burst panels when runnin small shots.

Anonymous · Post by **Anonymous** » Sun Jun 08, 08 10:12 pm

pete walton wrote:Adam how much compression is it safe to have with nitrous?????
If i am 12.5 comp would it be a good idea to o ring the block

Just curious

No problem runnin nitrous with the compression you have , DC will determine cylinder pressures anyhow.

Tight quench motors don't fair too well when running on the bottle with heavy hits.

Pete · Post by **Pete** » Sun Jun 08, 08 10:13 pm

Julies motor is 500 ci, 12.5:1. 683 lift cam, large valves and Max Wedge ports.

Motor does not start hauling to at least 4500 rpm, so its not great off the line. Pulls like a train to 7000rpm.

I realise most of the spray would be exiting out the exhaust ports, but I need to pick up a few tenths on the launch - there is plenty of MPH there

.

Pete · Post by **Pete** » Sun Jun 08, 08 10:17 pm

Might be an option - I will talk to the "Box-Miester".

We though that motor would stand the Dart on its bumper , but it did not happen............Sox has a transbrake, so that should be fun..