Rocker Shafts
Moderator: Moderators
-
Dave-R
- Posts: 24752
- Joined: Sun Apr 18, 04 11:23 pm
- Location: Dave Robson lives in Geordieland
- Contact:
Well of course my rockers ARE offset otherwise they wouldn't line up with the pushrods! 
I can't afford new rocker shafts and rockers so I will just have to make do. I will cut a groove in the shafts though. I will make the grooves 20mm long and position them so that they center in the ROCKER and stop 5mm from each side of the rocker.
They are still a good fit on the shafts and I wouldn't even have known there was a problem if I hadn't taken them off so sod it - I will re-use them.
I can't afford new rocker shafts and rockers so I will just have to make do. I will cut a groove in the shafts though. I will make the grooves 20mm long and position them so that they center in the ROCKER and stop 5mm from each side of the rocker.
They are still a good fit on the shafts and I wouldn't even have known there was a problem if I hadn't taken them off so sod it - I will re-use them.