Page 2 of 2
Posted: Mon May 18, 15 8:56 am
by Pete
There you go - cartoon car version:
Posted: Mon May 18, 15 10:27 am
by vipergts
latil wrote:Take the lowering blocks out and see how it looks.
At Penshurst today? If not it's your cars twin.
Yeah that was me...should have said ello
OK I'll raise the rear......Were and what size U bolt thingies can I get/need?
What I really need is a 285 tyre
Posted: Mon May 18, 15 10:32 am
by Pete
They DID make 285 tyres - Roydon has a pair.........."U" bolts will probably fit BUT in theory you are supposed to change them once you have taken them off though many people do re-use them....They are to fit 3" Tube, WASP used to sell them, not had to come by.....
Posted: Mon May 18, 15 11:02 am
by Blue
Hausers probably has the correct U bolts.
Posted: Mon May 18, 15 11:27 am
by latil
Tyres are listed by Coker and BFG stateside,if they are allowed here now.
Penshurst,not me,my lads were there.
Posted: Mon May 18, 15 12:01 pm
by vipergts
Cheers Guys
I''come back with my findings
Posted: Mon May 18, 15 5:27 pm
by RobTwin
charger01 wrote:295's fit no problem if you jack it up loads
Posted: Mon May 18, 15 6:47 pm
by charger01
Take a proper look at my car Rob . It isn't jacked up.It did however have rock hard rear suspension Unlike most of the Chargers and other b-bodys I have seen. The front was lowered on the torsion bars.
Posted: Mon May 18, 15 8:04 pm
by ANTON
Lee I have a set of bolts I stock.
Anton
Posted: Mon May 18, 15 8:49 pm
by drewcrane
Is there any place that can re arch the springs? that is what alot of yanks do and some add a leaf,
I replaced the leaf springs on my challenger, cause they sagged right from the factory, and I bought new springs 2 years ago and they already sag, just my
your car looks great either way ,
Re: Does this need raising?
Posted: Mon May 18, 15 9:28 pm
by Roger
vipergts wrote:Been toying with this for a while and it Bananarama! me
Does this need raising? I know they should have that typical stance but not keen on the drastic stance but I'm thinking this almost looks like the rear suspenders has broken?
It has 1.5" blocks currently?
Id lower the front. Back looks just right
Posted: Mon May 18, 15 9:46 pm
by vipergts
ANTON wrote:Lee I have a set of bolts I stock.
Anton
Cheers Anton....Maybe I'll leave it until it comes your way.
Roger....Front is already too low really as I get bump steer and arms and rods already at the wrong angles
Posted: Mon May 18, 15 9:48 pm
by Mossy68
Thought Fetish would have been straight on this. ?
