Posted: Thu May 28, 15 10:07 pm
Miles, see page 8 of my workshop thread:
http://www.moparuk.com/forums/viewtopic ... &start=105
Took the extension off the starter as it was impossible to get it in with it on.
Wire it up before you install.........you should be able to feed it between the exhaust and torsion bar. All I did is have it rotated 90 degrees around the mounting bolts. Push past torsion bar, rotate it back inline with the bolt holes and then feed it in!
If your doing the headers, do yourself a favour and do it at the same time (one less obstacle)!
http://www.moparuk.com/forums/viewtopic ... &start=105
Took the extension off the starter as it was impossible to get it in with it on.
Wire it up before you install.........you should be able to feed it between the exhaust and torsion bar. All I did is have it rotated 90 degrees around the mounting bolts. Push past torsion bar, rotate it back inline with the bolt holes and then feed it in!
If your doing the headers, do yourself a favour and do it at the same time (one less obstacle)!