Mopar Muscle Association UK

Next mod ... just had to get shut of the Cali tail pipes. The new tails are s/steel 3”dia with a 2.25”ID inlet. Had to add a short length of 2.25” pipe to the tails to get them to protrude out far enough from under the car after cutting the droopy bit off. Have used the rear hanger u-bolts to clamp the tails on pics ...

Nice Simon i have some awesome tips for my Duster they came of DemonGs prize winning Dodge Demon so as you would expect they are good and not repos just need to get them fitted i am also going to order some from Year one for the Roadrunner they have Red stripes on them wich i will paint Blue to match the paint work.

That a good looking car great job on the boot replacement.

The wheels and tail pipe look very much at home,
I like the black panels on the bonnet, you don`t see that very often,
She sure looks purdy.

Cool colour...gives the car its character...
Richard.

Cracking motor Simes (but then I would say that )


I see you have the evaporation control system fitted mate

Bucks Charger wrote:Cool colour...gives the car its character...
Richard.

Clivey wrote:Cracking motor Simes (but then I would say that )

thanks guys!!

Clivey wrote:I see you have the evaporation control system fitted mate

yeah, wasn’t sure what to do with all that when the tank went back up after the trunk floor was done, do those 4 pipes need to be connected or can they be capped off?? The gas tank vents thro the filler cap right?? The gizmo in the trunk that looks like a piece of scaffold tube is present, and there’s a fifth pipe that runs forward (following the same path as the fuel pipe) to the engine bay, where it is capped off!! So I guess the ECS is present but not connected to anything?? Can all the redundant plumbing be removed??

I’m probably going to need a new gas tank sometime in the future, I noticed when it was off that the top side is quite rusty and it must be getting a bit thin!! I’ve seen replacement gas tanks listed with and without connections for the ECS, I guess I could get one without the connections if the ECS isn’t connected to anything up front??

Sorry Si

Hadn't seen this thread

didnt know you'd replaced the boot floor

very nice job

just had my seats retrimmed, picked them up from DM’s this morning, cheers Dave, great job . that’s me busy at the weekend then …

Thats looks nice Simon i must see DM about my Duster Bench Seat you Charger is turning into a some car!

refurbished seats in , covers from WASP, retrimmed at Dave Madders emporium, pics …

passenger door mirror fitted , purchased from http://www.pgclassic.com/ , what these photos don’t convey is that I checked the position of the screw/bolt holes by measuring off of the driver side about 75,432 times, as the saying goes, measure 75,432 times, drill once!! pics …

Old folks, like Budgie, would say...they look nice and comfy!

Good Job Simothy,

HWats the crack with that instrument cluster - your gauges are all over the place. Is that an after market one?