Page 40 of 41
Posted: Wed Mar 14, 12 7:42 am
by ANTON
more
Posted: Wed Mar 14, 12 8:11 am
by autofetish
keep the picture coming this is a great build

Posted: Wed Mar 14, 12 8:47 am
by Jules
Remote door locks huh
Nice touch

Posted: Wed Mar 14, 12 10:03 am
by Matt74
Looking' good

Posted: Wed Mar 14, 12 10:12 am
by ANTON
Jules wrote:Remote door locks huh
Nice touch

Part of the alarm system but does make unlocking the car much easier. I can also open the trunk at the push of the button.
Posted: Wed Mar 14, 12 8:04 pm
by R.RUNNER
Posted: Tue Mar 20, 12 4:31 pm
by ANTON
I wanted to but new window guide but after seeing how much they were I decided to repair what I had and it came out great.
I brought some self adhesive mohair tape and set about recovering the plastic guide on the front edge of the front window.
Posted: Wed Mar 21, 12 7:09 am
by ANTON
Picked up the final few bit from the powder coaters this morning and the new tank came out great.
Posted: Wed Mar 21, 12 7:25 am
by Philb
What are you like Anton

Tank picked up from coaters and pictures posted all before 7.30am ! Looks great, wont be sucking up any crap from that tank

Posted: Sat Mar 24, 12 12:23 am
by steveo
Posted: Sat Mar 24, 12 9:13 am
by DaveB
Just make sure non of the powders gone in the tank Anton

Posted: Mon Mar 26, 12 10:09 pm
by Rich
Posted: Mon Mar 26, 12 10:32 pm
by vipergts
That's good work Anton
Keep it up....my car soon
Posted: Tue Mar 27, 12 8:11 am
by autofetish
DaveB wrote:Just make sure non of the powders gone in the tank Anton

From what i understand the powdercoating is not affected buy petrol
i was planning to power the inside of my tank well try (might change my mind now)
Advice ????
Anton amazing work as always where did you get your mohar tape ?
Posted: Tue Mar 27, 12 8:47 am
by RobTwin
I dunno what it would be like on the inside of a tank but I know the two dont mix very well on the outside of an inlet manifold under a leaky carb
Before
A few years after
