Page 1 of 15
Posted: Wed May 30, 07 11:58 pm
by Anonymous
Damn, despite best efforts, I seem to have been captured on film.
Little steps, Dave, and you'll get there.

Posted: Thu May 31, 07 12:42 am
by Anonymous
Petrolhead wrote:That's my Nodding Dashboard Sandy


Posted: Thu May 31, 07 9:09 am
by Dave-R
I asked my dog what he thought of it. He answered "Rough".

Posted: Thu May 31, 07 4:17 pm
by Anonymous
I imagine the scuttle panel will be the most fun to fix!
Posted: Thu May 31, 07 8:00 pm
by Dave999
jammy begger
you even got some of the plastic trim bits for the seats

Posted: Thu May 31, 07 8:05 pm
by Dave999
you don't fix them
you just carve a new one out of filler
however it is very worth putting a lot of time and effort into the seam between it the plenum underneath and the windscreen apature
this is where the water that gets under the screen rubber goes
and that rusts out everything beneath in about 6 months....nice!
tis a feature of all aussie vals
Dave
Posted: Fri Jun 01, 07 12:23 am
by Anonymous
these things are popping up all over the place

Posted: Fri Jun 01, 07 11:10 am
by Anonymous
Well it was only a matter of time before everyone realised their potential

Posted: Fri Jun 01, 07 11:24 am
by latil
Bit late,they've nearly all rusted away

Posted: Fri Jun 01, 07 2:40 pm
by Anonymous
Petrolhead wrote:I think I'm missing a section of trim from under the grill,
i think your missing a slightly bigger piece of the car than that......like a door maybe
(someone had to say, just thought it would be me for a change)
Posted: Fri Jun 01, 07 3:26 pm
by Dave999
yup there is a spoiler needed under there.
like a pressed steel bottom lip to the mouth
two bolts each end and a strut in the middle down to the k frame
might be quite hard to find.
could allways ask aussie pete for his
or
ask Ray at PP&R to keep a look out for ya.
He's a stand up guy who likes to expand his buiness across the global village
www.pentastarparts.com.au
looking good
have you got 2 sets of doors ??
Dave