Page 1 of 1
Posted: Tue Sep 04, 07 8:54 am
by Dave-R
All you need is a nut and bolt.
Drill a hole. Weld the nut to the case over the hole. Put a nut and nylon washer in the hole.
Nothing simpler.
Posted: Tue Sep 04, 07 5:32 pm
by Dave-R
I can't remember. But it wouldn't have been metric.
The bigger the bolt the faster the oil will flow out. But the bigger the danger of hitting it on something.
Posted: Tue Sep 04, 07 10:24 pm
by Kev
10mm will be fine, especially if you take the fill plug out, should drain quick enough. Bet it's empty by the time you've taken all the nuts off, before you have to whack poo out of it to break the seal.....
Posted: Wed Sep 05, 07 4:57 pm
by Dave999
just put the cover on upside down
Dave
sorry
Posted: Wed Sep 05, 07 7:08 pm
by Dave-R
What cover? They don't have them.
Posted: Wed Sep 05, 07 7:33 pm
by Kev
Posted: Thu Sep 06, 07 11:45 am
by morgan
I need to change the oil on mine... (its been nagging at me as something I have not done yet).
This sort of answers a question I was gonna ask...
Morgan.
Posted: Thu Sep 06, 07 1:43 pm
by Kev
Are you going to drill a hole to get the oil out?
Posted: Thu Sep 06, 07 5:15 pm
by Dave999
Dave wrote:What cover? They don't have them.
damn ya get me everytime
dave
