Mopar Muscle Association UK

try using this
http://www.mymopar.com/hpcalc1.htm
would my RR weigh 4100 with me in ?
if so works out at 519bhp is this fairly acuarate ?
b r l 3700 pounds = 564bhp ?
put duncan chally in at 9.4 & gives a cool 951


can you tell im well board- not allowed to go to work today
Im a real christmas barr-hum-bug

574bhp For the Sox with the last motor. Sounds a bit low. DTD gives 622bhp.

350hp for the cab, 150 drugs, 200 motor?

Something's adrift. stock 318 2bbl is 230hp

exactly!

Is this rear wheel HP or crank?

It gives me 460.

Must be rear wheel HP. If you factor in about 70hp to drive the trans that gives me 530hp which would be about right.

andyrob wrote:try using this
http://www.mymopar.com/hpcalc1.htm
would my RR weigh 4100 with me in ?
if so works out at 519bhp is this fairly acuarate ?
b r l 3700 pounds = 564bhp ?
put duncan chally in at 9.4 & gives a cool 951


can you tell im well board- not allowed to go to work today
Im a real christmas barr-hum-bug

that engine was makin circa 900-920 hp,

i would reckon your runner with you in approx 3,9201bs

orange chall came out at 916 hp
blue chall came out at 726 hp
and when the orange chall had the hemi heads on the factory 440 block with terrible ring seal 720 hp

these things work a lot better on mph than ET
your MPH is usually pretty consistent even if ETs are all over the place due to traction issues, etc...

http://www.mymopar.com/hpcalc.htm

Mine works out as 445hp now (down from 460 doing it the other way) which agrees with my theory that it was falling flat at the top end.

That is for sure rear wheel HP.

That brings mine up to 582 bhp using mph. I think that is rear wheel horesepower.

Julies worked out at 387bhp.................

Occording to that calculator, in 2006 before the cam + headers were fitted and with no oil pressure, I was running 196