Mopar Muscle Association UK

Posted: **Sun Jan 13, 08 4:58 pm**

I`ve now got my superstock springs,I`ve also got a pair of e body front hangers, the bolt pattern is the same, can someone run a tape measure from the mounting hole (for spring) to the part of the body where the hanger bolts on ( b body) just trying to save a few quid ,or if someone has the dimensions for the springs/hangers....thanks

Posted: **Sun Jan 13, 08 7:05 pm**

Just measured mine,centre of front spring bolt to body ,three and a quarter inches.

Posted: **Sun Jan 13, 08 7:38 pm**

thanks chip

Posted: **Sun Jan 13, 08 7:49 pm**

are they standard? just measured the E body hangers & they measure 4 -1/4" are your springs super stock? super stock springs are `A` body length & longer front hangers are required to fit them to anything else(I thought) these E body hangers are an inch longer than standard

I was hoping to use the E body hangers that I got with the ss springs

Posted: **Sun Jan 13, 08 8:14 pm**

Not sure Jerry , they were on the car when i got it. From what you say I would say there standard.If you need any more measurements let us know.

Posted: **Tue Jan 15, 08 7:10 pm**

Right, standard front hangers on my coronet measure 3 1/4" this is from the spring mounting hole to the face of bracket (where it mounts),I have a pair of E body(i` ve been told) which measure 4 1/4" I tried these last night and they still mount the axle about 1" further forward

which means my tyres will catch

can anyone who `s got a b body fitted with superstock springs please measure this size ,or do all superstock springs cause this problem

Posted: **Sat Jan 26, 08 6:14 pm**

Dont you know anyone that could fabricate a couple of longer hangers for you.
Mick

Posted: **Sat Jan 26, 08 10:34 pm**

When i fitted my superstock springs , they fitted straight on to my front hangers , or am i reading it wrong?

Have you got the correct springs?

Posted: **Sun Jan 27, 08 11:05 am**

The straight (not offset) Super Stock front hangers you use depends on the wheelbase you have.

The E-body front hangers you have should also fit 108/110/115" WB B-body cars (1964-65, 1971-74 Hard Top)

However your car is a 117" WB (1966-70 Dodge B-Body Sedan and Wagon) is it not? In which case they are probably too short.

Posted: **Mon Jan 28, 08 9:24 pm**

spot on dave,and expertly put, the hangers I need are 5 1/14" long(mounting face to c/l of bolt hole) which is 2" longer than standard,and 1" longer than the e body ones,cheers

Posted: **Sat Feb 02, 08 12:09 am**

Gerry
Take them into any small fabrication co and i'm sure they will make a longer pair, without charging you a fortune, then sell your others on here.
Mick