Mopar Muscle Association UK

Hi there, after a bit of advice on this.

Is there a "standard" position to fit these (i.e. to give maximum caster) or is it a question of "to meet your own requirements".

Is this impacted by the ride height of the vehicle?

I want to put some off-set bushes in Julie's car before we take it out again.

All help gratefully appreicated, thanks.

Make sure you 'get em right' before you press em in.

I install for maximum caster - i.e the front inner bush offset towards the engine , and the rear one towards the wheel. Ride height may have some influence on the max camber and caster settings you can obtain , but I don't think this important enough that you should adjust the installation position.