Page 1 of 2
Interiour pic's required.
Posted: Mon Sep 15, 08 6:14 pm
by Trigger_Andy
Could someone with a '70 - '74 Barracuda tale some interiour shots for me,please? Since the previour owner fitted the new carpets he never noted the holes/bolting points of the Seat Belts or the Sun Visors. I dont have a center consol and dont think this will make a diference but you never know.
Any help would be much appreciated.
Posted: Mon Sep 15, 08 10:10 pm
by RoelB
Andy, for the seatbelts you can push something thin and sharp from underneath the car into the carpet. All the seatbelt hole are visible from underneath.
I include a pic of the sunvisor, driver side. Again, if you feel with your finger, there will be a large middle hole, with 3 small holes for the screws.
Hope this help
Roel
Posted: Mon Sep 15, 08 10:16 pm
by Trigger_Andy
Nice one roel!
I was not sure if the Seat belt hole's went through or where threaded. Is it the same deal for the rear?
Posted: Tue Sep 16, 08 8:19 am
by RoelB
Andy, the rear bolt into a boxsection, as far as I can remember. I'll take a pic tonite
Posted: Tue Sep 16, 08 4:48 pm
by Trigger_Andy
Cheers Roel,
any chance of a couple of Piccies of the Power Steering pump and where it mounts, the front of the engine (belts basicaly) too,please?
Posted: Tue Sep 16, 08 7:09 pm
by RoelB
Andy, the middle belts in the rear bolts next to the prop tunnel, you can see that from underneath. The side ones are only visible if you have the rear seat out
roel
Posted: Tue Sep 16, 08 7:23 pm
by Trigger_Andy
Thanks Roel, I really appreciate it! Nice clean looking car by the way!
Posted: Tue Sep 16, 08 7:52 pm
by Trigger_Andy
Oh, are the inertia reels for the rear seats?
Posted: Tue Sep 16, 08 8:18 pm
by RoelB
front, next to the door
Posted: Tue Sep 16, 08 8:20 pm
by Trigger_Andy
Cheers! I'm gonna workout that Jigsaw tomorrow, and hunt the holes!
Posted: Wed Sep 17, 08 12:12 pm
by Trigger_Andy
I'm not having much luck with these Seat Belts
I have a 3 point rear belt set up but can only find two holes. Both under the Rear Seat. I cant find the top third hole anywhere! I'veeven removed the plastic trim. Are these cars ment to have 3 point rear belts? They look genuine and period enough.
I've found the mounting hole for the Inertia reel but it seems to sit in way!
Posted: Wed Sep 17, 08 2:39 pm
by Trigger_Andy
Sorry to harp on about this.
Looking in the Duster the Inertia reels are for the Rear Seats. I can feel what feels like a hole under the new Headlining that could be a bolt hole. If it is could the 3 point Seat Belts be for the front? I dont wanna cut a hole in the nice new lining and its also glued down.
Posted: Wed Sep 17, 08 3:19 pm
by Cannonball
andy
i reckon your inertia belts are for the front if they are correct, they fix against the inner sill just behind each front seat, one part must go up to the roof area above the reel, they were a different belt setup on the 73 on cars i am sure
Posted: Wed Sep 17, 08 3:41 pm
by Trigger_Andy
Cheers Dunc,
looking at what little interiour pictures there is on-line my Inertia Reel seems to be facing the wrong way. Ie sticking out on the horizontal as opposed to coming out the top. Its almost imposible to wind out the reel in this position. Behind my rear seat looks different to Roel's too. If the Inertia was in the back it would still work ok coming out of the side of the Inertia unit. I'm almost 100% sure there is no third mounting point in the rear.
All belts have Chrysler written on them.
Some piccies........
Posted: Wed Sep 17, 08 5:39 pm
by Cannonball
they must be rears, the fronts are much bigger