Posted: Wed Dec 17, 08 8:24 pm
yep was an orange gremlin, him and another geezer sold the parts out of two day vans not got conntact details sorry
Page 1 of 1
Posted: Wed Dec 17, 08 8:34 pm
That was Alan Knight, he used to be down in Surrey, don't have a current number for him I'm afraid.
Posted: Wed Dec 17, 08 9:53 pm
If you are in Northants you may as well go to Geof Hauser for the crank balance. You will need the crank, rods, pistons, pins, and damper. Probably cost about £200 I would think??
Make sure your torque converter is not offset weighed for external balance. Otherwise you will have to include that in the equation too.
Make sure your torque converter is not offset weighed for external balance. Otherwise you will have to include that in the equation too.
Posted: Wed Dec 17, 08 9:57 pm
Dave, Geof sends it all away to be done
Try
Bob Harmon, @ BHP in Watford, sutton road ...highly recommended
Try
Bob Harmon, @ BHP in Watford, sutton road ...highly recommended
Posted: Wed Dec 17, 08 11:22 pm
T`was Alan Knight and his brother Dave,they used to go by the name of OTE racing(on the edge).Great pair of geezers but not seen them anywhere this season.Had tons of stuff off them over the years but I`m sure they dont sell stuff now.Bet he still has the 11 sec Gremlin stuffed away somewhere though..
Posted: Thu Dec 18, 08 2:52 pm
These chaps will do you a spanky new balancer
http://www.romac.com.au/balancers_US.html
should set you back about £150 + post age at todays exchange rate
http://www.romac.com.au/balancers_US.html
should set you back about £150 + post age at todays exchange rate
Posted: Thu Dec 18, 08 4:58 pm
Dave have you got a link to a distributor for romac can't get the one on that site to work.
Ta Jerry
Ta Jerry