Page 1 of 1
superstock springs pattern??
Posted: Sat Feb 28, 09 7:31 pm
by black8driver
hi all.
i need some new springs for my 67 barracuda.
i was wondering if anyone has the patterns or knows for any with measurement to make superstock springs..
will make some myself to make it a bit cheeper..
anyone??
si
Posted: Sat Feb 28, 09 8:13 pm
by AllKiller
You made springs before ?
they arent that expensive...and A body designated
Posted: Sat Feb 28, 09 8:32 pm
by black8driver
AllKiller wrote:You made springs before ?
they arent that expensive...and A body designated
i hope there not expensive would save me a bit of work tbh... where from?
yes i can make springs not too difficult really use the right steel and get them tempered or temper then myself although id have to make my own oven done small springs but bigger ones its harder to get even heating so may shop that out i dunno yet...
had springs made for around 80 quid for sa pair before so may just get that done, not worth bothering for that price tbh but still need specs/patterns...
anyone???
si
Posted: Sat Feb 28, 09 8:43 pm
by Blue
Yep, I made a set a few years back, might still have the drawings, I'll see if I can find them.
Posted: Sat Feb 28, 09 8:50 pm
by black8driver
Blue wrote:Yep, I made a set a few years back, might still have the drawings, I'll see if I can find them.
hey that would be excellent if u have...
ive tryed to search for them but no luck as yet..
si
Posted: Sat Feb 28, 09 8:53 pm
by Blue
Found 'em, just emailed it to you.
Posted: Sat Feb 28, 09 9:15 pm
by black8driver
Blue wrote:Found 'em, just emailed it to you.
spot on bloke recieved with thanks..
let the build commece..
si
Posted: Sat Feb 28, 09 9:29 pm
by black8driver
Blue wrote:Found 'em, just emailed it to you.
only thing i havent got it the centre of axle to the first spring...
i suppose i use the std spring center for that?
si
Posted: Sat Feb 28, 09 10:25 pm
by Blue
Yep, standard A body length.