Mopar Muscle Association UK

For membership to a Canadian club, I played with Potatoshop...

Now that looks superb, Have at it!

Can't be that difficult, can it? Could I use the stock beam? I know some of the blokes way back used to use A100 axles...

Narrow the rear a few inches, Or do I have to? Keep stock springs.

It's the look I like. Whaddya think?

Is the stock beam mounted under the springs? If it is then it's dead easy to raise the front up a tad. If you want to radiarise the rear arches, then you'd want a wider rim in the right offset to move the wheel out a bit. No axle narrowing required. All in all I don't think it would be that hard to do at all.

jeffs just bloody teasin again blue,
did you buy the gremlin jeff??????????????

Thanks for the phone call Blue..... Just waiting for a reply on the wheels. WOW! they is "well cool" Will be measuring it all up this weekend.

Just going out to have a measure up for the front beam.... And I have to make a decision on wether to have the rear arches cut out!

Thing is, I can change the whole look of this truck, quickly without chucking too much money at it!

At a later date, once I have moved. A 400ci will fit in the bay with no mods to the sheet metal needed! So, I can finally see a plan for the ol truck!