Page 1 of 1
HURST ROLL/CONTROL
Posted: Fri Apr 01, 05 5:30 pm
by Ashley
Been out and about today trying to get the fittings to fit it.
Guess what nobody has anything suitable.
Any one got any been told there eighth bsp tapered thread 3/16 line.
What ever that is.
Any help would be very nice cheers fella's.
Posted: Fri Apr 01, 05 8:28 pm
by Kev
Over the counter at Customville in Ilford or mail order from SpeedFlow.Co.Uk.
Posted: Fri Apr 01, 05 10:39 pm
by Rich
Thats exactly what I need for my Moroso line-lock.Went to my local Yank place and they had 1 in stock and said it should not be a problem to get another,,,,,,,,But it has been.Off to Speedflow for a look ,Cheers Kev.(asming this is not an April 1st wind up)
Posted: Fri Apr 01, 05 10:55 pm
by latil
Old cookers , gas fires , boilers common on the pipework Not that I look in skips of course
Posted: Fri Apr 01, 05 11:10 pm
by Ashley
Thank's Kev.
Not a wind up Rich ( Keep smilling fella ).
Posted: Sun Apr 03, 05 7:14 pm
by Rich
Well I got no joy at Speedflow.
Are you anywhere near this Customville place Kev??Would it be possible to pck up a few of these and send them out to us??If not have you got a phone no for them please?
The fitting is 1/8 BSP on one end and the other end takes a standard 3/16 male brake pipe fitting..
Any help mucho apriciated as this 1 fitting is the last piece in my brake jig saw..
Posted: Sun Apr 03, 05 7:55 pm
by Guy
Richard try Stateside thats were I got mine from
Posted: Sun Apr 03, 05 8:06 pm
by Kev
I used this;
http://www.speedflow.co.uk/z816.htm
Plus the nut to join the (flared) brake line to the JIC end.