Page 1 of 1
Rallye Dash Wood Grain Transfers
Posted: Mon Sep 27, 10 11:37 am
by Anonymous
Has anybody used these on their rallye dash? If so, did they look ok / crap / brilliant? Need to replace mine but dont particularly want to go for the full ally face plate job as mine are in excellent condition.
Cheers thankyou please
C
Posted: Mon Sep 27, 10 11:56 am
by Dave-R
I have seen them and although not always a 100% perfect match when placed side by side, they do look good enough for 99% of people.
Posted: Mon Sep 27, 10 12:04 pm
by Dave-R
Posted: Mon Sep 27, 10 1:59 pm
by Anonymous
No B Body Rally Dash woodgrain transfer
Posted: Mon Sep 27, 10 2:46 pm
by ANTON
Hi Clivey
Get some wood grain fablon and do it yourself.
Fablon is heat sensitive so you can mold it to the dash.
Do A trial bit and see how it comes out.
Posted: Mon Sep 27, 10 5:47 pm
by RobTwin
Woodgrain Fablon worked a treat on that console you dontated Clivey
Few quid a roll, so no harm in trying!
(unless you get it wrong & it pulls the old woodgrain off
)
Posted: Wed Sep 29, 10 7:55 am
by Anonymous
Thanks for the advice guys, but I need the lettering for the switches knobs n dials. I also need a new radio surround as the original was cut for an after martket job. I think I'll have to take the pain and make a purchase. Oh well, only £380-ish. I want the dash back in the car ASAP.
