Page 1 of 2
halloween event
Posted: Sun Oct 17, 10 1:27 pm
by Mick
I am thinking of going, wondered if anyone else is.
I am also after a single bottom pulley if anyone has one, i believe small and big block are the same.
Mick
Posted: Sun Oct 17, 10 7:14 pm
by challenger
hoping to be there mick, got some new heads to fit first and not a lot of time to do them
Posted: Mon Oct 18, 10 2:50 pm
by Mick
Alloy heads Jim ?
Posted: Mon Oct 18, 10 6:10 pm
by challenger
yes indeed mick brought me some eddy performers while i was in the states
Posted: Tue Oct 19, 10 12:32 am
by Mick
Great news, i see 11's in you future.
Mick
Posted: Tue Oct 19, 10 8:04 am
by Jon Connolly
Edelbrocks look good Jim
If the weather`s OK will try and get up there with the Valiant and do a bit of fine tuning
Posted: Tue Oct 19, 10 6:53 pm
by challenger
hopefully see you fellas up there for a
or 2
Posted: Wed Oct 27, 10 9:45 pm
by Mick
Has Avon park got a proper track dryer now.
Mick
Posted: Sun Oct 31, 10 6:03 pm
by Mick
Unfortunately. i had to work yesterday, the pennies pay for the playtime.
Anyway, got there today unloaded and scrutineered the car pulled in line and the rain started and continued all day.
Looking on the brightside, i didn't blow the car up and got to chew the fat with Jim and a few others.
Mick
Posted: Sun Oct 31, 10 6:18 pm
by Dave-R
Did Jim get any runs in?
Posted: Sun Oct 31, 10 6:28 pm
by challenger
hey dave, yes got a few runs but couldnt stop wheelspinning off the line, my last run was full lock left and right off the line
reckon my slicks am dead aswell as dampish track, plus gained a puncture in one slick
so best run with lots of wheel spin was 12.2@111mph motor is definatley stronger with them heads
Posted: Sun Oct 31, 10 7:21 pm
by Mick70RR
Well done Jim, is that a PB?
Posted: Sun Oct 31, 10 7:39 pm
by challenger
no mick, would of been for sure if i got some traction. 12.1@111 is my best, that was 12 months ago
Posted: Sun Oct 31, 10 7:49 pm
by Mick70RR
I've not had a PB all year, last one was the HRD last year.
Posted: Sun Oct 31, 10 8:43 pm
by Anonymous
Keep on keepin on Jim.