Page 1 of 1
Panel holding/butting clamps for welding
Posted: Sat Dec 14, 13 8:31 am
by MilesnMiles
Guess the welding guys know of these, but I thought they were neat.
http://www.eastwood.com/intergrip-panel ... -of-4.html
Posted: Sat Dec 14, 13 8:46 am
by autofetish
some in the uk
http://www.ebay.co.uk/itm/Intergrips-We ... 589af72d30
looks great but have still never brought any.
Posted: Sat Dec 14, 13 9:06 am
by Mick
I notice he twisted the toggle from behind to lift it out, what if you cant get access to the back of the plate ?
Mick
Posted: Sat Dec 14, 13 9:19 am
by Pete
Cleco pins..
Posted: Sat Dec 14, 13 10:06 am
by autofetish
Posted: Sat Dec 14, 13 11:38 pm
by Mick
So they dont work unless you can access the back of the panel.
Posted: Sat Dec 14, 13 11:42 pm
by autofetish
Mick wrote:So they dont work unless you can access the back of the panel.
correct but you could undo them and hope that square bar falls out to a place you can get to
a cleco pin will work when you cant get in there.
I just use magnets
Posted: Mon Dec 16, 13 8:14 am
by MattH
I used them on the Challenger rear quarters to join along their length , they are great and give a small enough gap to produce a perfect weld.