Page 1 of 1
grant Mopar steering wheel boss,to euro style wheel adapter.
Posted: Thu Aug 07, 14 9:52 pm
by Johnny Dart
Does any one know if there is an adapter available ,to allow the fitting of a European style after market steering wheel , to a Grant Mopar adapter hub/boss ?
I have a steering wheel I want to use , but its not a Grant one. I have a Grant adapter.
Posted: Fri Aug 08, 14 7:51 am
by autofetish
A dodge viper is the same splines as you steering rack ( so I read on a lot of posts)
I had same issue was going to get a viper one but not that far yet
Posted: Fri Aug 08, 14 12:24 pm
by Johnny Dart
This is the steering wheel,with euro style fixings.
And to the right ,the Grant 3 hole fixings.
Posted: Fri Aug 08, 14 1:16 pm
by Blue
Grant make a Mopar 6 bolt boss as well, probably the best solution.
Posted: Sat Aug 09, 14 8:38 am
by ANTON
Get a 9mm bit of ali and drill and countersink the three holes for the grant boss and then fix the ali to the grant boss and then drill and tap the six hole into the ali spacer to fit the wheel job done. You may have to cut the centre out to make the euro horn button work.
Posted: Sat Aug 09, 14 2:14 pm
by Johnny Dart
ANTON wrote:Get a 9mm bit of ali and drill and countersink the three holes for the grant boss and then fix the ali to the grant boss and then drill and tap the six hole into the ali spacer to fit the wheel job done. You may have to cut the centre out to make the euro horn button work.
I was hoping that I could buy a ready made one , to save some time that I don't have
I may have located one, for a Chrysler, I've ordered it, just waiting for it to arrive, and fingers crossed its the correct spline.
Will keep you all posted.
If its the correct one its very good value.
