Page 1 of 1
Checking deck to bore square ?
Posted: Mon Sep 29, 14 7:10 pm
by Johnny Dart
Engine shop surgested I had the deck to bore checked for square before I had it bored. ( and charge me for doing so obviously )
Is this somthing perculier to Mopar engines, as I have never had it checked before ?
Posted: Mon Sep 29, 14 7:30 pm
by latil
Normal for any engine if you want it right,should also check the crank is square to the bores too. Who's doing it? That firm up Lottbridge Drove?
Posted: Mon Sep 29, 14 7:31 pm
by mopar_mark
Good recommendation by your shop
Posted: Mon Sep 29, 14 7:34 pm
by Johnny Dart
Latil, I did ask but they can't bore V8s on thier machine.
Thats ok then, i supose its par for the course with race engines.
Julian Godfrey race engines in Heathfield East Sussex.just up the road from me.
Posted: Mon Sep 29, 14 8:20 pm
by Adrian Worman
mopar_mark wrote:Good recommendation by your shop
