Page 1 of 1

Holden Commodore Vu Ute

Posted: Fri Apr 07, 17 7:19 pm
by Johnny Dart
I imported a 2001 Holden Commodore SS Ute from Australia last September.
I need some front discs and pads.
Do any of you Holden buffers know if they were fitted to something else ( Opel Omega ) may be, or have any part number interchanges, that might help me get some from the local motor factors.
Thanks
Johnny

Posted: Fri Apr 07, 17 7:27 pm
by Pete
Roger - Monkfish Performance - is your man for that!

Posted: Fri Apr 07, 17 8:02 pm
by Johnny Dart
Yes thanks, I had heard of them,but being in the Motor trade , I hoped I could get them from a local/national motor factors, if I could give them some part numbers to cross referance :thumbright:

Posted: Fri Apr 07, 17 8:15 pm
by Johnny Dart
Just had a look at the web page, they don't seem to list standard discs and pads.

and judging by the prices I think It would be a lot cheaper importing them from OZ :shock:

Posted: Fri Apr 07, 17 8:54 pm
by Roger
Thanks Pete :)

How much cheaper do you need?

http://www.monkfishperformance.co.uk/br ... 219972.htm

Pads: http://www.monkfishperformance.co.uk/br ... 024018.htm

Dont waste your time cross referencing, they dont.

Look at the 04 CV8 monaro pages. The ute pages on the website are a bit of an out of date backwater.....................

Posted: Fri Apr 07, 17 9:40 pm
by Johnny Dart
Roger wrote:Thanks Pete :)

How much cheaper do you need?

http://www.monkfishperformance.co.uk/br ... 219972.htm

Pads: http://www.monkfishperformance.co.uk/br ... 024018.htm

Dont waste your time cross referencing, they dont.

Look at the 04 CV8 monaro pages. The ute pages on the website are a bit of an out of date backwater.....................
Hi Roger,
Thanks for pointing me in the right direction,
I couldn't find that on your site,only up grades.
I will peruse :thumbright:

Posted: Fri Apr 07, 17 10:12 pm
by Roger
No problem :) Just go here. "most" of it reads over directly to your car. There are some anomolies with over 4500 parts, so not everything is listed. Plus we are breaking a ute and a commodore.

If its says "in stock" then we actually have it on the shelf.

http://www.monkfishperformance.co.uk/in ... 8-57-parts

If you cant find something, just drop me a mail.

Posted: Sat May 20, 17 10:36 pm
by Johnny Dart
I fitted some stainless steel tubular extractor manifolds today.
I imported them from the USA, 5 times cheaper than if imported from Australia.
Seat of the pants dyno , says noticeable torque and pick up increase. :thumbright
ImageImage