Mopar Muscle Association UK

Anyone fitted a 2 speed motor ,where once was a 3 speed.
Need some advice , 3 speed has four wires from bulkhead block to motor.
The 2 speed has three wires going into a block on the motor.
Just need to know what wire does what and which terminal on the 2 speed to connect to.
Thanks Steve.

I hope this helps you, it is from 68 manual

Thanks cadboy any info is appreciated, I can cross reference that with my 66 diagram. Just need to know where on the 2 speed motor they go, as I will be using separate crimps in stead of a plug.
Sure its an easy job, I have asked for info on the forbbodies forum in the States, .you,d think i was inventing the wheel.
Don't think they get the make it fit ethos.

Unless it's bondo Steve they'll spend days on that

you don't have to change any wiring, you fit a two speed wiper and a two speed switch and it will work,
you cant mix switches or motors though, they have to be correct for each other,

Thanks Jinx Jay.