Page 1 of 1
Front suspension seals
Posted: Mon Aug 23, 04 2:11 pm
by Ivor
Can anyone tell me why the rubber seal kits from Year One or Mancini have five track and tie rod seals and one round spongy seal for the idler, when all six should all be the same?
Or am I losing it again?
Posted: Mon Aug 23, 04 2:44 pm
by Alex
The spongy seal goes where the bolt goes through the frame !
Posted: Mon Aug 23, 04 5:00 pm
by Ivor
So that means they all supply one seal short!
there are four seals on the tie rods and two on the drag link, which makes six, if I'm not mistaken.., and as far as a bolt going through the frame Alex, you've got me there.
Good mind to stick the lot in the truck and show you, I'm in your neck of the woods tomorrow!
Posted: Mon Aug 23, 04 5:18 pm
by Alex
Sure, call round for a brew man !!