Page 1 of 1
Power R&P for Mopars
Posted: Sat Aug 05, 06 10:52 am
by Dave-R
Posted: Sat Aug 05, 06 11:06 am
by steveo
looks tempting , would like to see one fitted
Posted: Sat Aug 05, 06 10:21 pm
by MrNorm
It got discussed on Moparts a few months ago, looks good but not cheap ($1100 for the kit with pump etc), and was still being developed - had only been tested on B-Body with stock exhaust, apparently no bump steer but headers might be a problem.
I would email unisteer and see what they say!
Posted: Sat Aug 05, 06 10:34 pm
by steveo
the rack gators look like they are going to be a problem with headers , or at least run to close and melt them,
Posted: Sun Aug 06, 06 9:59 am
by Dave-R
Thanks guys. I will pass the information on to an interested party.
Posted: Sun Aug 06, 06 1:58 pm
by TrevD
i can see another potential problem with this , the bracket might be a little weak for the aplication , i would like to see some mounting rear of the rack as its very low and might be the first contact point on things like speed humps.
Posted: Thu Aug 17, 06 10:13 pm
by AllKiller
My first thought that bracket looks puny
What about a manual R+P for the same ?? less gumpf on the motor...justa stronger bracket