Page 1 of 1
73 cuda woodgrain dash help
Posted: Sat Aug 05, 06 12:12 pm
by newport100
Hi
I have acquire a 2 piece adhesive decal kit for my Cuda - minus he instructions. I have heard that these are hard to get right? Any instructions tipe etc would be most appreciated!
Thanks
Mark
Posted: Tue Aug 15, 06 10:30 pm
by steveo
i replaced the wood grain on my centre console , this might help , degrease the where the sticker goes , start at one edge, make sure it is straight, pull the backing off slowly ,& back on its self wile pushing the wood grain down rubbing it side to side being carefull not to get air bubbles . hope this makes seance. more or less the same as sticking decals on
Posted: Wed Aug 16, 06 7:44 am
by Alex
Bilko has got the right idea, take your time and it will be fine.
Posted: Wed Aug 16, 06 8:37 am
by newport100
Cheers
Is it best to try & remove the old woodgrain?. If I stick it over the existing one - what about the raised wiper/lights etc labels? These will show through and cause bublles (i would guess)
Ta again
Mark
Posted: Fri Oct 06, 06 9:38 pm
by newport100
Mo
Hi mate - and thanks for the reply- sorry for the delay in replying. I managed to order a complete set with ally backing from PG classics in the end- but cheers for the message - catch up with you at he next show maybe
Regards
Mark
Posted: Wed Oct 11, 06 9:31 pm
by AllKiller
Mine is a back to front, copy on and aluminium sheet to accomodate the quik shifter but look stock ish.
Not many notice, woodgrain adesive plastic from a hardware store.
Posted: Thu Oct 12, 06 1:34 am
by RobTwin
newport100 wrote:Mo
Hi mate - and thanks for the reply- sorry for the delay in replying. I managed to order a complete set with ally backing from PG classics in the end- but cheers for the message - catch up with you at he next show maybe
Regards
Mark
or come down the next Herts/Beds meet.... oops just missed one
