rear screen charger fitting

Anonymous · Post by **Anonymous** » Mon Feb 12, 07 8:32 pm

How do i fit a rear screen in a charger. Im Told you dont use a rubber. do you have to use a cork gasket and stick it in with windor sealer or something? any special tools needed?

Anonymous · Post by **Anonymous** » Mon Feb 12, 07 8:50 pm

You use a window glass sealer,be careful though,if it aint in right you won't get yer trims on after.Also don't forget yer clips go in first,& make sure there the right ones

Look in yer fsm,they give you the spacer measurements you need for the clips/trims.

Anonymous · Post by **Anonymous** » Tue Feb 13, 07 7:51 am

Clips go in like this Craig

Anonymous · Post by **Anonymous** » Tue Feb 13, 07 7:23 pm

the clips are a terrible water trap, i would stick the stainless trim in with some black silicone sealant/adhesive, thats what i did and got rid of the clips

Anonymous · Post by **Anonymous** » Wed Feb 14, 07 7:52 am

sean68charger wrote:the clips are a terrible water trap, i would stick the stainless trim in with some black silicone sealant/adhesive, thats what i did and got rid of the clips

Interesting. Did they seat ok?

Anonymous · Post by **Anonymous** » Wed Feb 14, 07 6:43 pm

yep, lots of masking tape to hold them down and a broom of the flourecent light!!!

Anonymous · Post by **Anonymous** » Wed Feb 14, 07 6:54 pm

Might have a job getting em back out

Mind you,prob the best way to fit em

I take it your glass wasn't sitting in right,or you forgot the clips.

Anonymous · Post by **Anonymous** » Wed Feb 14, 07 7:42 pm

decisions decisions. 2 ways to go.

Anonymous · Post by **Anonymous** » Thu Feb 15, 07 8:44 pm

no, i deliberately left the clips off as they are a serious corrosion issue, the rear screen nearly fell out because of them on my pontiac