Curious noise

Moderator: Moderators

Post Reply
User avatar
Stu
Posts: 7111
Joined: Sun Jul 31, 05 4:15 pm
Location: Shropshire, home of the worlds smallest big screen TV

Curious noise

Post by Stu »

Took the Barracuda out for a good old cruise today, all windows down despite being freezin' at pace! 8-) Did get an unsettling noise, though.

Under acceleration, mostly at lower speeds (30-40ish) there is a definite "click" as you put your foot on the gas. It is louder when booting it at lower speed (and yes, I know the engine gets louder as you gas it, making the noise quieter :roll: but this is noticably different.)

Difficult to tell where it's coming from, sounds like its coming from the trans tunnel sometimes, and from the rear sometimes. You can't feel it through the peddle, just get the noise!

Any ideas? (Go gentle with me, I'm still learning...) :read2:
24 hours in a day, 24 beers in a case. Coincidence? I think not…

70 Challenger
MMA/489
NSS/435
Steve Chapman
Posts: 1862
Joined: Wed Jan 10, 07 4:03 pm
Location: North Yorkshire

Post by Steve Chapman »

Stu, could be worn uj or axle u bolts loose
1965 Coronet
User avatar
Stu
Posts: 7111
Joined: Sun Jul 31, 05 4:15 pm
Location: Shropshire, home of the worlds smallest big screen TV

Post by Stu »

Cheers, Chip. Will check it out at the weekend when we can get it up on the lift.
24 hours in a day, 24 beers in a case. Coincidence? I think not…

70 Challenger
MMA/489
NSS/435
User avatar
Ivor
Site Admin
Posts: 13000
Joined: Sun Apr 18, 04 11:11 pm
Location: The village of Evenley

Post by Ivor »

I would check the trans mounting as well, get underneath and see if you can move it around... :roll:
The pump don’t work coz the vandals took the handles.

www.ivorsroadrunner.com
User avatar
Pete
Posts: 22109
Joined: Sun Apr 18, 04 10:49 pm
Location: MMA Chairman

Post by Pete »

Torque Convertor bolt loose?

Swap it all out and convert it to Big Block :evil: a sort of "Cure-all" solution....
Pete Wiseman; Cambridge.

Mopar by the grace of God
Anonymous

Post by Anonymous »

If the torque convertor bolt comes lose, you will hear it with the engine ideling, as the flex plate will be "slapping" the convertor, or worse still , cutting into the block.

You'll find the noise will disappear when you take the rpm up, as the convertor will pull into the box. Assuming it has just started to loosen off.

I would pull the dust cover & check it anyway.
User avatar
Stu
Posts: 7111
Joined: Sun Jul 31, 05 4:15 pm
Location: Shropshire, home of the worlds smallest big screen TV

Post by Stu »

Weekend got by without chance to get under it.. :evil: Thanks for the suggestions though, chaps, will try and get to it during the week and report back. 8-)
24 hours in a day, 24 beers in a case. Coincidence? I think not…

70 Challenger
MMA/489
NSS/435
Post Reply