uper ball joint

Anonymous · Post by **Anonymous** » Fri Jan 04, 08 6:34 pm

hello all ,any of you ss no if this washer or spacer should go on before bush ,after bush or not at all ,seems i have one balljoint with one on and not other ,thanks Andy sorry its a crap pic

Pete · Post by **Pete** » Fri Jan 04, 08 7:21 pm

I do not think they are fitted as standard. Sometimes I have used them before the nut (but after the knuckle) to get the right level of engagement so that the split pin is snug.

steveo · Post by **steveo** » Fri Jan 04, 08 8:19 pm

true i had washers for the upper ball joints for the charger from PST , my originals did not have them , like Pete says stick the ball joint stud through the top of the spindle then the washer on the other side then the nut

Anonymous · Post by **Anonymous** » Fri Jan 04, 08 9:34 pm

thanks all