ball joint rubber

Anonymous · Post by **Anonymous** » Fri Jan 04, 08 10:11 pm

another question to all you mopar boffs ,which do you think are top and bottom balljoint rubbers ,thanks again

steveo · Post by **steveo** » Sat Jan 05, 08 12:42 am

look inside if it has a slight serrated look to the inside or a if one has a stiffening ring of steel in the bottom that is for the top , as it is a push click click fit on the ball joint , if none of this is on the polyurethane boots , i think the taller boot is for the top as the angle of the top ball joint is greater , so would need longer boot ,

but it could also be for the bottom as because the top is thick , it does not look like it is for much movement

, hmmmmmmmmm , try one with out bolting it up to see witch one seals the best on the top & bottom

Jules · Post by **Jules** » Sat Jan 05, 08 1:24 am

I'm sure I've put the taller neck rubber (the one to the right in your picture) to the top ball joint.

Save my pic and zoom in if you can.

Hope it helps.

Jules.