HURST ROLL/CONTROL

Ashley · Post by **Ashley** » Fri Apr 01, 05 5:30 pm

Been out and about today trying to get the fittings to fit it.
Guess what nobody has anything suitable.
Any one got any been told there eighth bsp tapered thread 3/16 line.
What ever that is.
Any help would be very nice cheers fella's.

Kev · Post by **Kev** » Fri Apr 01, 05 8:28 pm

Over the counter at Customville in Ilford or mail order from SpeedFlow.Co.Uk.

Rich · Post by **Rich** » Fri Apr 01, 05 10:39 pm

Thats exactly what I need for my Moroso line-lock.Went to my local Yank place and they had 1 in stock and said it should not be a problem to get another,,,,,,,,But it has been.Off to Speedflow for a look ,Cheers Kev.(asming this is not an April 1st wind up)

latil · Post by **latil** » Fri Apr 01, 05 10:55 pm

Old cookers , gas fires , boilers common on the pipework Not that I look in skips of course

Ashley · Post by **Ashley** » Fri Apr 01, 05 11:10 pm

Thank's Kev.
Not a wind up Rich ( Keep smilling fella ).

Rich · Post by **Rich** » Sun Apr 03, 05 7:14 pm

Well I got no joy at Speedflow.
Are you anywhere near this Customville place Kev??Would it be possible to pck up a few of these and send them out to us??If not have you got a phone no for them please?
The fitting is 1/8 BSP on one end and the other end takes a standard 3/16 male brake pipe fitting..
Any help mucho apriciated as this 1 fitting is the last piece in my brake jig saw..

Guy · Post by **Guy** » Sun Apr 03, 05 7:55 pm

Richard try Stateside thats were I got mine from

Kev · Post by **Kev** » Sun Apr 03, 05 8:06 pm

I used this;
http://www.speedflow.co.uk/z816.htm
Plus the nut to join the (flared) brake line to the JIC end.