Interiour pic's required.

Trigger_Andy · Post by **Trigger_Andy** » Mon Sep 15, 08 6:14 pm

Could someone with a '70 - '74 Barracuda tale some interiour shots for me,please? Since the previour owner fitted the new carpets he never noted the holes/bolting points of the Seat Belts or the Sun Visors. I dont have a center consol and dont think this will make a diference but you never know.

Any help would be much appreciated.

RoelB · Post by **RoelB** » Mon Sep 15, 08 10:10 pm

Andy, for the seatbelts you can push something thin and sharp from underneath the car into the carpet. All the seatbelt hole are visible from underneath.
I include a pic of the sunvisor, driver side. Again, if you feel with your finger, there will be a large middle hole, with 3 small holes for the screws.
Hope this help
Roel

Trigger_Andy · Post by **Trigger_Andy** » Mon Sep 15, 08 10:16 pm

Nice one roel!

I was not sure if the Seat belt hole's went through or where threaded. Is it the same deal for the rear?

RoelB · Post by **RoelB** » Tue Sep 16, 08 8:19 am

Andy, the rear bolt into a boxsection, as far as I can remember. I'll take a pic tonite

Trigger_Andy · Post by **Trigger_Andy** » Tue Sep 16, 08 4:48 pm

Cheers Roel,
any chance of a couple of Piccies of the Power Steering pump and where it mounts, the front of the engine (belts basicaly) too,please?

RoelB · Post by **RoelB** » Tue Sep 16, 08 7:09 pm

Andy, the middle belts in the rear bolts next to the prop tunnel, you can see that from underneath. The side ones are only visible if you have the rear seat out
roel

Trigger_Andy · Post by **Trigger_Andy** » Tue Sep 16, 08 7:23 pm

Thanks Roel, I really appreciate it! Nice clean looking car by the way!

Trigger_Andy · Post by **Trigger_Andy** » Tue Sep 16, 08 7:52 pm

Oh, are the inertia reels for the rear seats?

RoelB · Post by **RoelB** » Tue Sep 16, 08 8:18 pm

front, next to the door

Trigger_Andy · Post by **Trigger_Andy** » Tue Sep 16, 08 8:20 pm

Cheers! I'm gonna workout that Jigsaw tomorrow, and hunt the holes!

Trigger_Andy · Post by **Trigger_Andy** » Wed Sep 17, 08 12:12 pm

I'm not having much luck with these Seat Belts

I have a 3 point rear belt set up but can only find two holes. Both under the Rear Seat. I cant find the top third hole anywhere! I'veeven removed the plastic trim. Are these cars ment to have 3 point rear belts? They look genuine and period enough.

I've found the mounting hole for the Inertia reel but it seems to sit in way!

Trigger_Andy · Post by **Trigger_Andy** » Wed Sep 17, 08 2:39 pm

Sorry to harp on about this.

Looking in the Duster the Inertia reels are for the Rear Seats. I can feel what feels like a hole under the new Headlining that could be a bolt hole. If it is could the 3 point Seat Belts be for the front? I dont wanna cut a hole in the nice new lining and its also glued down.

Cannonball · Post by **Cannonball** » Wed Sep 17, 08 3:19 pm

andy
i reckon your inertia belts are for the front if they are correct, they fix against the inner sill just behind each front seat, one part must go up to the roof area above the reel, they were a different belt setup on the 73 on cars i am sure

Trigger_Andy · Post by **Trigger_Andy** » Wed Sep 17, 08 3:41 pm

Cheers Dunc,
looking at what little interiour pictures there is on-line my Inertia Reel seems to be facing the wrong way. Ie sticking out on the horizontal as opposed to coming out the top. Its almost imposible to wind out the reel in this position. Behind my rear seat looks different to Roel's too. If the Inertia was in the back it would still work ok coming out of the side of the Inertia unit. I'm almost 100% sure there is no third mounting point in the rear.

All belts have Chrysler written on them.

Some piccies........

Cannonball · Post by **Cannonball** » Wed Sep 17, 08 5:39 pm

they must be rears, the fronts are much bigger