Broken Axle half shaft?

Steve Chapman · Post by **Steve Chapman** » Thu Feb 19, 09 7:44 pm

You can get the oil out, done it for years on HGVs, if you have access to some gas bottles, flash over the surface with it,but dont go too mad or you,ll cook the lining. After just clean the soot off with some Emery or Sandpaper.

TYREMAN · Post by **TYREMAN** » Thu Feb 26, 09 1:52 pm

Is fixed now on both sides

thanks for the help.I have still not done any proper hooning in her yet as the some day the bearings were done the Rad decided to spring a leak!

some radwell has put a stop to it for now

but better get the Rad redone or replaced soon to be safe.

I also have some burnt fingers replacing the plugs while the motor is still hot

them shock towers on these Fords make it a pain to get to the middle plugs,you cant beat a Mopar engine bay

Kev · Post by **Kev** » Thu Feb 26, 09 4:08 pm

So was it just bearings?

TYREMAN · Post by **TYREMAN** » Thu Feb 26, 09 9:27 pm

Kev wrote:So was it just bearings?

Yes Kev

the Bearing had burst the seal to the half shaft.