Out with the old.

RayC · Post by **RayC** » Fri Feb 15, 08 8:20 pm

ave you opened it up at all yet adam me old lad??????????? how do yer revs seem

Anonymous · Post by **Anonymous** » Mon Mar 10, 08 7:20 pm

Think i've found the problem why the pit was all over the track @ the top end , causing me to have to back off.

Found out the Pit had just over half an inch of toe out , this was all spose to of been aligned last year.

Should of clicked when i noticed the scrubed tyres.

Thanks to D Billydoos for talking me through it today.

DaveB · Post by **DaveB** » Tue Mar 11, 08 9:19 pm

Anonymous · Post by **Anonymous** » Mon Apr 21, 08 6:50 pm

I had a good look round the pit yesterday, Chargers aren't really my cup of tea but pics don't really do the car justice! Its a credit to you Adam

Anonymous · Post by **Anonymous** » Mon Apr 21, 08 7:34 pm

Thanks Marc , nice of you to post a comment.

I take it you were @ Dave Billydooooos yesterday.

JustinMFox · Post by **JustinMFox** » Tue Apr 22, 08 7:50 pm

Note the sign above the pit : )

Anonymous · Post by **Anonymous** » Tue Apr 22, 08 8:02 pm

Well , it's on the trailor comming back from Dave Bs , be with me around midnight , it's been a relief not bein here for two weeks , as i have'nt had the chance to think what toy to fit next , saved me some $$$$$$$$$$

Anonymous · Post by **Anonymous** » Fri Jun 19, 09 4:16 pm

Brutus is in trouble

NaughtyAlan · Post by **NaughtyAlan** » Fri Jun 19, 09 4:40 pm

Would this be his MAIN concern

Pete · Post by **Pete** » Fri Jun 19, 09 4:43 pm

Talking in riddles again...

Ivor · Post by **Ivor** » Fri Jun 19, 09 4:57 pm

Perhaps it's a quiz?

Anonymous · Post by **Anonymous** » Fri Jun 19, 09 7:20 pm

Blimey , what an old thread

Anyhows , as posted before i saw this thread re erected...................

#3 main bearing is toast , convertor gave it a good hidiing , crank endfloat was 0.005" when built , checked endfloat today & measures 0.040" , gonna pull it out & check it over.

NaughtyAlan · Post by **NaughtyAlan** » Fri Jun 19, 09 7:31 pm

Brutus wrote:Blimey , what an old thread

Anyhows , as posted before i saw this thread re erected...................

#3 main bearing is toast , convertor gave it a good hidiing , crank endfloat was 0.005" when built , checked endfloat today & measures 0.040" , gonna pull it out & check it over. Tonight

Anonymous · Post by **Anonymous** » Fri Jun 19, 09 7:40 pm

Motor should be back in around midnight , just gotta get over to Bobs & pick the bearings up , will be in me local around 12.30 for a late one , can't let the little one's down as there lookin forward to goin to the Ace tommorow.

Mopar Muscle Association UK

Out with the old.

Up up and away in my beautifull ballon