Rallye Dash Wood Grain Transfers

Anonymous · Post by **Anonymous** » Mon Sep 27, 10 11:37 am

Has anybody used these on their rallye dash? If so, did they look ok / crap / brilliant? Need to replace mine but dont particularly want to go for the full ally face plate job as mine are in excellent condition.

Cheers thankyou please

C

Dave-R · Post by **Dave-R** » Mon Sep 27, 10 11:56 am

I have seen them and although not always a 100% perfect match when placed side by side, they do look good enough for 99% of people.

Dave-R · Post by **Dave-R** » Mon Sep 27, 10 12:04 pm

I would use http://www.performancecargraphics.com/

Anonymous · Post by **Anonymous** » Mon Sep 27, 10 1:59 pm

No B Body Rally Dash woodgrain transfer

ANTON · Post by **ANTON** » Mon Sep 27, 10 2:46 pm

Hi Clivey

Get some wood grain fablon and do it yourself.
Fablon is heat sensitive so you can mold it to the dash.
Do A trial bit and see how it comes out.

RobTwin · Post by **RobTwin** » Mon Sep 27, 10 5:47 pm

Woodgrain Fablon worked a treat on that console you dontated Clivey

Few quid a roll, so no harm in trying!

(unless you get it wrong & it pulls the old woodgrain off

)

Anonymous · Post by **Anonymous** » Wed Sep 29, 10 7:55 am

Thanks for the advice guys, but I need the lettering for the switches knobs n dials. I also need a new radio surround as the original was cut for an after martket job. I think I'll have to take the pain and make a purchase. Oh well, only £380-ish. I want the dash back in the car ASAP.