Cam degreeing

Blue · Post by **Blue** » Sun Feb 20, 11 5:18 pm

Have checked a few in situ with a Moroso wheel and it clears Ok. In my experience, it's been the timing set that is out rather than the cam. Have used Rollmaster and 440 Source billet sets and they were fine as is. Any Cloyes set I have ever used has needed to be adjusted, one in particular was so far out of whack I couldn't use it. In my opinion it is worth the effort of checking so that you are sure it's correct. Should the engine not perform as it should, you will end up checking it anyway.

Anonymous · Post by **Anonymous** » Sun Feb 20, 11 5:26 pm

Hi Guys,

Anton had a Comp Cams dual roller chain-set that was nearly a whole tooth OUT!!!

Chinese junk!

Bacca, uses Aussie stuff, its made proper!!!!!!!!!!!!!!!!!!!!!!!!!!