Bent Wheel studs

GTXJim · Post by **GTXJim** » Fri Apr 15, 11 1:19 pm

Now it's starting to make sense, unfortunately there's none about with a centre locator, so I may need to get a drawing done and get either Anton's mate or TrevD to make some, also buy some new studs

TrevD · Post by **TrevD** » Fri Apr 15, 11 7:28 pm

if you can draw them up i can sort them no problem (make sure you measyre the boss on the shaft and bore in the wheel acurately)

GTXJim · Post by **GTXJim** » Fri Apr 15, 11 7:33 pm

No Prob's Trev I will get one sorted asap

TrevD · Post by **TrevD** » Sun Apr 17, 11 12:45 pm

just knocked these up for myself to put some 17" rims on my mitsubishi fto, these are 8mm thick, once fitted to the hub they wont come off again, and they are 4.5"pcd (same as mopar)

GTXJim · Post by **GTXJim** » Sun Apr 17, 11 2:13 pm

Trev, that's exactly what I want 10mm thick 175mm in diameter 4 1/2" x 5 bolt patten studs 1/2", centre needs to be 72mm to clear center hub and 71mm to clear centre of wheel, here's a side view( apologies for dreadful drawing) Can you knock up a couple please

TrevD · Post by **TrevD** » Sun Apr 17, 11 5:53 pm

i can do that no problem apart from the 175mm, not sure if i have any material in stock that size (i will check), are you sure those measurements are correct, i would expect a normal imperial measurement.

GTXJim · Post by **GTXJim** » Sun Apr 17, 11 8:06 pm

How about 7" in diameter or 180mm instead of 175mm

TrevD · Post by **TrevD** » Mon Apr 18, 11 6:52 am

i think the bigest i have in stock is 5 3/4, i will have a look thisevening