Trans cooler fittings

Jon · Post by **Jon** » Mon Aug 15, 05 2:34 pm

I'm going to plumb the original trans cooler on my car in line with the aftermarket one thats on now for a little extra cooling, the fittings on the rad are missing. does anyone know off the top of their head what thread they are
its a 26" rad in a 69 charger

Anonymous · Post by **Anonymous** » Mon Aug 15, 05 4:47 pm

I should have them here Jon will check and let you know

Jon · Post by **Jon** » Mon Aug 15, 05 5:40 pm

cheers

Anonymous · Post by **Anonymous** » Mon Aug 15, 05 6:30 pm

They should be 1/4 npt Jon now i only have these in a 90* with -06 AN on the other end, this would connect to -06 braided fittings

let me know if they are any use to you

Blue · Post by **Blue** » Mon Aug 15, 05 6:30 pm

If you mean the thread into the rad it's 1/8" NPT.

Anonymous · Post by **Anonymous** » Mon Aug 15, 05 6:38 pm

I just quoted the size out of my catalogue so must be a misprint, either way i got em in a 90* elbow if they are any use

Trigger_Andy · Post by **Trigger_Andy** » Mon Aug 15, 05 6:45 pm

I can get any sized npt fittings in stainless and other more exotic materials for you guys for free!! Cross overs, elbows, tee pieces ect. Just let me know what you require and ill grab some when im next off-shore. 5-10,000 psi rated too!!

Anonymous · Post by **Anonymous** » Mon Aug 15, 05 6:50 pm

Figured out what are 1/4, it's the aftermarket coolers from the same place as my catalogue, DOH