E body front flexi pipes what size fitting at each end

AllKiller · Post by **AllKiller** » Tue Sep 25, 12 12:09 pm

specifically i need to know exactly what the fitting/thread size is at the hard line connecting end on the front flexi pipe on an E body Barracuda

Or any helpful links please ....need to make up my Viper Caliper to stock Cuda flexi lines.
thanks in advance

I dont want to take them off just yet to check

AllKiller · Post by **AllKiller** » Wed Sep 26, 12 10:50 am

Wheres Robo when you need him ?

Pete · Post by **Pete** » Wed Sep 26, 12 10:52 am

Sorry Steve, I can't remember but I am sure they are 24TPI......I am sure Speedflow could advise you.

Pete

Dave-R · Post by **Dave-R** » Wed Sep 26, 12 11:04 am

I don't remember stuff like that any more Steve. It's all gone from my head. Even Challenger stuff.
Not sure I ever knew that particular thing though. Richard Ehrenberg gave me the front flexys and I think it was Jon Benn that sorted a rear one for me after I sent him my old one as a pattern.

Adrian Worman · Post by **Adrian Worman** » Wed Sep 26, 12 11:11 am

http://www.getdiscbrakes.com/drop/Catal ... E-Body.pdf

AllKiller · Post by **AllKiller** » Fri Sep 28, 12 6:21 pm

Cheers Chaps, Ades post has helped i gave them a bell

Blue · Post by **Blue** » Fri Sep 28, 12 6:43 pm

3/8" x 24TPI if I remember right...

AllKiller · Post by **AllKiller** » Sun Sep 30, 12 11:02 pm

Nice one Blue