68 Charger Upper Ball Joint tool

Pete · Post by **Pete** » Fri Jan 02, 15 4:36 pm

Well done - I would have bet my Balls to a Barn dance that the LCA bushes would be kippered - makes the car wander badly at speed, especially with the factory settings with too little caster for modern driving........

mr m · Post by **mr m** » Fri Jan 02, 15 10:48 pm

Hi I got a sway bar with brackets off 68 383 charger if any good just 10 mins from anton

Pete · Post by **Pete** » Fri Jan 02, 15 10:55 pm

mr m wrote:Hi I got a sway bar with brackets off 68 383 charger if any good just 10 mins from anton

You have gotta love this club

Glen63 · Post by **Glen63** » Sat Jan 03, 15 10:22 am

Hi Mr M

That sounds like what I am looking for, will PM you to exchange phone numbers etc. Do you know what diameter it is ?

Now just need those big block torsion bars, anybody ?

If not Anton said I should contact Wasp for a price on a new set from USA.

morgan · Post by **morgan** » Sat Jan 03, 15 11:48 am

Go new on the torsion bars. There's too much hanging on them IMHO and you might not be able to spot damage/weakened bits.
If you got the $ ( you just got a 2nd gen charger after all

) then there are some uprated/hemi stuff available. Hotchkis ones are monsters. Toughen it up though...

Mopar Muscle Association UK

68 Charger Upper Ball Joint tool

suspension

Re: suspension