Does this need raising?

Pete · Post by **Pete** » Mon May 18, 15 8:56 am

There you go - cartoon car version:

vipergts · Post by **vipergts** » Mon May 18, 15 10:27 am

latil wrote:Take the lowering blocks out and see how it looks.
At Penshurst today? If not it's your cars twin.

Yeah that was me...should have said ello

OK I'll raise the rear......Were and what size U bolt thingies can I get/need?

What I really need is a 285 tyre

Pete · Post by **Pete** » Mon May 18, 15 10:32 am

They DID make 285 tyres - Roydon has a pair.........."U" bolts will probably fit BUT in theory you are supposed to change them once you have taken them off though many people do re-use them....They are to fit 3" Tube, WASP used to sell them, not had to come by.....

Blue · Post by **Blue** » Mon May 18, 15 11:02 am

Hausers probably has the correct U bolts.

latil · Post by **latil** » Mon May 18, 15 11:27 am

Tyres are listed by Coker and BFG stateside,if they are allowed here now.

Penshurst,not me,my lads were there.

vipergts · Post by **vipergts** » Mon May 18, 15 12:01 pm

Cheers Guys

I''come back with my findings

RobTwin · Post by **RobTwin** » Mon May 18, 15 5:27 pm

charger01 wrote:295's fit no problem if you jack it up loads

charger01 · Post by **charger01** » Mon May 18, 15 6:47 pm

Take a proper look at my car Rob . It isn't jacked up.It did however have rock hard rear suspension Unlike most of the Chargers and other b-bodys I have seen. The front was lowered on the torsion bars.

ANTON · Post by **ANTON** » Mon May 18, 15 8:04 pm

Lee I have a set of bolts I stock.

Anton

drewcrane · Post by **drewcrane** » Mon May 18, 15 8:49 pm

Is there any place that can re arch the springs? that is what alot of yanks do and some add a leaf,

I replaced the leaf springs on my challenger, cause they sagged right from the factory, and I bought new springs 2 years ago and they already sag, just my

your car looks great either way ,

Roger · Post by **Roger** » Mon May 18, 15 9:28 pm

vipergts wrote:Been toying with this for a while and it Bananarama! me

Does this need raising? I know they should have that typical stance but not keen on the drastic stance but I'm thinking this almost looks like the rear suspenders has broken?

It has 1.5" blocks currently?

Id lower the front. Back looks just right

vipergts · Post by **vipergts** » Mon May 18, 15 9:46 pm

ANTON wrote:Lee I have a set of bolts I stock.

Anton

Cheers Anton....Maybe I'll leave it until it comes your way.

Roger....Front is already too low really as I get bump steer and arms and rods already at the wrong angles

Mossy68 · Post by **Mossy68** » Mon May 18, 15 9:48 pm

Thought Fetish would have been straight on this. ?

Mopar Muscle Association UK

Does this need raising?

Re: Does this need raising?