73 cuda woodgrain dash help

newport100 · Post by **newport100** » Sat Aug 05, 06 12:12 pm

Hi

I have acquire a 2 piece adhesive decal kit for my Cuda - minus he instructions. I have heard that these are hard to get right? Any instructions tipe etc would be most appreciated!
Thanks

Mark

steveo · Post by **steveo** » Tue Aug 15, 06 10:30 pm

i replaced the wood grain on my centre console , this might help , degrease the where the sticker goes , start at one edge, make sure it is straight, pull the backing off slowly ,& back on its self wile pushing the wood grain down rubbing it side to side being carefull not to get air bubbles . hope this makes seance. more or less the same as sticking decals on

Alex · Post by **Alex** » Wed Aug 16, 06 7:44 am

Bilko has got the right idea, take your time and it will be fine.

newport100 · Post by **newport100** » Wed Aug 16, 06 8:37 am

Cheers
Is it best to try & remove the old woodgrain?. If I stick it over the existing one - what about the raised wiper/lights etc labels? These will show through and cause bublles (i would guess)

Ta again

Mark

newport100 · Post by **newport100** » Fri Oct 06, 06 9:38 pm

Mo

Hi mate - and thanks for the reply- sorry for the delay in replying. I managed to order a complete set with ally backing from PG classics in the end- but cheers for the message - catch up with you at he next show maybe

Regards

Mark

AllKiller · Post by **AllKiller** » Wed Oct 11, 06 9:31 pm

Mine is a back to front, copy on and aluminium sheet to accomodate the quik shifter but look stock ish.
Not many notice, woodgrain adesive plastic from a hardware store.

RobTwin · Post by **RobTwin** » Thu Oct 12, 06 1:34 am

newport100 wrote:Mo

Hi mate - and thanks for the reply- sorry for the delay in replying. I managed to order a complete set with ally backing from PG classics in the end- but cheers for the message - catch up with you at he next show maybe

Regards

Mark

or come down the next Herts/Beds meet.... oops just missed one