sway bar bushes

Anonymous · Post by **Anonymous** » Wed Aug 16, 06 6:18 pm

i got these bushes for my charger, i take it there correct?
Any fitting tips. do i have to cut a slit in the top so it will fit round the bar.

latil · Post by **latil** » Wed Aug 16, 06 6:29 pm

They look right,should slide on with some silicon grease

steveo · Post by **steveo** » Wed Aug 16, 06 8:56 pm

mine were very difficult to put on , even with vice grips / g clamps silicone spray, etc & a hernia

still no go ,what i done carefully grind the weld at the top of the bracket , open it up slightly just enough to get the bush in then squeeze the bracket back together then carefully weld it up , making sure not to set the bush on fire . the bush slides on the bar first ,then the bracket . make sure the bracket is the correct way round before welding . don't cut the bush to fit it

Anonymous · Post by **Anonymous** » Wed Aug 16, 06 11:10 pm

steveo wrote:mine were very difficult to put on , even with vice grips / g clamps silicone spray, etc & a hernia still no go ,what i done carefully grind the weld at the top of the bracket , open it up slightly just enough to get the bush in then squeeze the bracket back together then carefully weld it up , making sure not to set the bush on fire . the bush slides on the bar first ,then the bracket . make sure the bracket is the correct way round before welding . don't cut the bush to fit it

:iagree:i had to do exactly the same espacialy if you are using polybushes