Brake line distribution block

[Rebel]

Really? did you just run the pipes from the master cylinder straight to the discs / drums, did you split them with a "T" piece to get to each wheel?

From the MC to a line-lock then onto a t-piece then to each front caliper. The proportioning valve was fitted to the chassis under the drivers seat in line with the brake pipe to the axle. I can reach the adjuster while sitting in the drivers seat.

Thanks Mick,

[ANTON]

Here's a picture of the wire. It goes into the harness and to the firewall plugs and then into the car.

[Rebel]

Thanks Anton, it's definitely missing on mine. I'll have to have a look under the dash to see if it's been tucked inside at some point or just removed altogether before looking to replace it