Mopar Muscle Association UK

Well the new hi torque starter fits & works a treat so result ! Thanks for all advice shaun

YAAAAAAAAAAY!!!!!!


and yes

8 volt coil with 12volt to it during the start cycle

hence my quip in a previous post about experimentation with the case of the alternator earthed

one of those wires switches it on

one of those wires doesn't but both are usually so mangled its hard to tell what colour they are.



Dave

Hi Dave I've left the other small wire disconnected as when I tested that terminal on the old starter it was dead even when operating the starter. Any idea what the ignition resistance should be as I want to buy a new one from my local factors ? My coil has 12volt stamped on the base along with use with resistor ? Thanks shaun

so you have a 12 volt coil with low resistance that needs a ballast.

I'm guessing yours has the electronic box

lucas DLB102 or DLB110

if you swap to an HEI module

Lucas DLB 198




Dave

Thanks Dave I bought a dlb102 today.