Can't get me head round it....again

Moderator: Moderators

Anonymous

Post by Anonymous »

Two thousand RPM @ 40 MPH.

Tis a dual speed convertor (dynamic) , but they won't say how it works. :?

:thumbright:
Mick
Posts: 3070
Joined: Sun Apr 18, 04 10:55 pm
Location: Nottingham

Post by Mick »

You're joking right, Dynamic is a good make but if you're going to use a lot of nitrous, you want a tight convertor, if it's too loose, the N20 will blow through it.
Mick
Anonymous

Post by Anonymous »

Hope not Mick , was no cheapie , around $900 , it's the 9 & half inch , fitted it before i went down the NOs route.

Tis a little ole plate system , not a fogger.
Anonymous

Post by Anonymous »

Another good reason to have the progresive controller , knew it would come in useful.

:thumbright:
User avatar
Kev
Posts: 13955
Joined: Sun Apr 18, 04 11:04 pm
Location: Brisbane, Oz.

Post by Kev »

Gay boy! :D
<center>
The name is Kev, nowadays known as Kevvy or Pommie C***!</center>
Anonymous

Post by Anonymous »

Got out of that one.

:lol: :lol:
Anonymous

Post by Anonymous »

Adam, A Frank Lupo is a nice piece, That must be a custom piece for that $$$$$, does it have Anti Ballooning plates for the NOS. Your car should be leaving like this on the motor with a Lupo in it........ :thumbright:
NaughtyAlan

Post by NaughtyAlan »

Kev wrote:Gay boy! :D







:D :D :D :D :D :D :D
Anonymous

Post by Anonymous »

Slick wrote:Adam, A Frank Lupo is a nice piece, That must be a custom piece for that $$$$$, does it have Anti Ballooning plates for the NOS. Your car should be leaving like this on the motor with a Lupo in it........ :thumbright:
Neil (Wil) knows a lot more about it than i do , think it has AB plates , will dig the info out.

Anyhow , who says it won't leave the line like that. ;)
Mick
Posts: 3070
Joined: Sun Apr 18, 04 10:55 pm
Location: Nottingham

Post by Mick »

Any decent convertor will cost that much.
My car also has a Dynamic.
What part No is yours Adam
Anonymous

Post by Anonymous »

Not sure , lost the paperwork on it. :roll:

Tis the 9.5 , stall speed three thousand two hundred.

:thumbright:
Anonymous

Post by Anonymous »

Slick wrote:Your car should be leaving like this on the motor with a Lupo in it........ :thumbright:
Depends what motors in it.

:thumbright:
Anonymous

Post by Anonymous »

That fury had a iron head 440 no gas full street trim and ran 11.35 was OKOS winner for the last 6 years, It had Street/Strip Dynamic in it and did not cost $415............ :thumbright:
Anonymous

Post by Anonymous »

May not have been that much , will find out tommorow.

:thumbright:
User avatar
AllKiller
Posts: 15191
Joined: Fri Jun 04, 04 9:33 pm
Location: Hampshire

Post by AllKiller »

I have a 3800 JW convertor in mine Adam, pulls a wheel up on launch, with a 125 shot of gas.... and 115 terminals and a 12.00 dead ET, with 28" slicks n 4.10's
after a few runs and getting back into the swing of it, i noticed it lay down a little mid track
so i think mine is fuel starvation around mid track thats why im upgrading the fuel system completely
To combat fuel flow struggling against launch, and the extra demand of the Nitrous fuel solenoid.
But still it gets good terminals ?? :?
ALL KILLER NO FILLER
Nostalgia, its not what it used to be.

Carbon footprint of a Saturn V
Image
Post Reply