If discs are wrapped slightly and hitting the inner pads , then if there is float / play on caliper slide pins then the caliper would wobble.
Just wondered if John had welded the mounts for caliper carriers onto axle as , if it like his front disc set up then ...........
If John did disc conversion the rear discs are probably second hand merc with ford Scorpio / sierra calipers second hand as well.
Have you done run out on discs? As well as half shaft flange
NOW what....bugger it
Moderator: Moderators
Yep the disc's are Merc 190 fronts and correct on the ford calipers, I didn't bother with checking the run out on the disc's but I did on the shaft flange and that was fine, hence I went and got new disc's70_charger wrote:If discs are wrapped slightly and hitting the inner pads , then if there is float / play on caliper slide pins then the caliper would wobble.
Just wondered if John had welded the mounts for caliper carriers onto axle as , if it like his front disc set up then ...........
If John did disc conversion the rear discs are probably second hand merc with ford Scorpio / sierra calipers second hand as well.
Have you done run out on discs? As well as half shaft flange