Page 4 of 4
Posted: Tue Jan 03, 12 9:36 pm
by Mick
Jerry Smith wrote:Ok I'll have a go les, my old 63 belvedere, weighed 3500ld without me so 3700 all in race weight, 500ci mopar mega block, ported Indy 440-1 heads 718/690 roller cam and 14.5-1 compression, was mini tubbed and on ladder bars running a 28x12 slick, best 60ft was 1.41 best et was 9.80@136.6 oh and it was registered and used occasionally on the street, had an msd timing retard in the car so could instantly knock 5-6 degrees out put in optimax and it'd cruise nicely,
One of the sweetest mopar motors i've ever heard.
I believe this was yours as well Jerry.
Posted: Tue Jan 03, 12 9:48 pm
by Jerry Smith
yes mick thats my old car, didnt realise at the time just how solid that car was when we restored it, one of the ones i should never have sold, although it doesnt apear to have it in that picture it was an airgrabber car
Posted: Wed Jan 04, 12 3:29 pm
by SteveCase
Run a 10 with iron heads and a 'little' 383!!!!
Posted: Wed Jan 04, 12 9:34 pm
by Mick
SteveCase wrote:Run a 10 with iron heads a 'little' 383 and only 200 hp shot!!!!
There you go Steve, fixed it for ya
Posted: Thu Jan 05, 12 8:39 am
by SteveCase
Posted: Wed Jan 18, 12 8:35 pm
by pete walton
Glen Appelgren in Sweden runs 11.57 with his all steel ,origional interier,383 with thermquad carb,,,and 516 heads ,,,,,engine cost as much as my house...No sniff just moter
Posted: Thu Jan 19, 12 12:14 am
by RayC
Mick wrote:baccaruda wrote:Hi Les,
Cookies Dart!
Used to run 8.3's at 180mph.
Street legal and all that stuff!
Now owned by Ray?
Me and Jimbo ran with an iron-headed 440 as funds were tight.
Ex Rob-Loring built motor, ex Grumpy's Dart?
Raised port 906's, 1/2'' spacers screwed to intake sides.
Steel crank, ali rods, venolia pistons 13 t0 1.
650 Crane roller cam with Crane Golds.
Team 'G' with 1050 street dominator.
4.56 gears and humungous tyres 31 x 16's.
Best run by Jimbo was 10.40 at 132ish.
That's pretty good, what weight was the car and what dur was the cam
Mick
Best run since Cookie 9.71 @ 138 mph
Posted: Thu Jan 19, 12 11:42 am
by Les Szabo
Yep, good numbers....to get well in the 9's on a 440ci on mtr is deffo 12:1 + CR, + heads, you just won't make 650 hp at 10.5:1 which is about what it takes to run that in an average weight back halved A-Bod.
